Shopping Cart

0 item(s) in cart/ total: $0    view cart
EMX Loop Sensor ( UltraII D-TEK)
EMX Loop Sensor ( UltraII D-TEK)

EMX Loop Sensor ( UltraII D-TEK)

Your Price:$109.95
Part Number:UltraII D-TEK

EMX Traffic Loop Detector - EMX Ultra 2 D-TEK Loop Detector

The EMX Ultra II D-TEK Vehicle Loop Detector was designed to be a more compact, energy efficient, cost effective and reliable detector that is easier to install and setup. Sensitivity selection is simplified by the ULTRAMETERTM display that indicates the appropriate sensitivity setting to detect the vehicle positioned on the loop. The 10 sensitivity settings allow for finer adjustment of the detection level, while the 4 frequency settings provide greater flexibility in preventing crosstalk in multi-loop applications.

EMX Ultra II D-TEK Vehicle Loop Detector
The EMX Ultra II D-TEK Vehicle Loop Detector delivers the features and benefits found in the EMX ULTRA D-TEK to all operator controls that require a dry contact relay input. The Ultra II D-TEK is also designed to plug into the ULTRA II Motherboard.

Sensitivity selection is simplified by the ULTRAMETER , which displays the appropriate sensitivity setting to detect the vehicle positioned on the loop.

Ten sensitivity settings enable finer adjustment of the detection level. And the four frequency settings provide greater flexibility in preventing crosstalk in multi-loop applications.
Benefits include:
Compact design
Energy efficient
Easy to install and setup
Reliable
Cost effective

Indicators and Controls
DIP SWITCH
4 positions that control frequency, ASB (automatic sensitivity boost) and Pulse/Presence (provides for reducing noise interference)
SENSITIVITY
Rotary switch is used to fine tune adjustment of loop detection height.
OUTPUT LED
The Red LED indicates the detection output status ULTRAMETERTM, Visual indicator of optimum loop sensitivity setting
POWER LED
During operation, the Green LED permanently ON indicates a normal operating condition; blinking indicates a loop failure condition.
FREQUENCY COUNT SWITCH
Momentary push button to check operating frequency of the loop. (indicated by the Red LED blinking at 10 kHz per blink).May also be used to hard re-set the Ultra DTEK

EMX Ultra II D-TEK Vehicle Loop Detector
Features
ULTRAMETER (displays optimum sensitivity setting / diagnostic aid)
Frequency count/reset switch
10 sensitivity settings
Loop diagnostics
4 operating frequencies
Lightning and surge protection
Frequency counter
Fail safe Operation

 Manual   Spec Sheet