Powermaster Model DSBG - DC Single Arm Barrier Gate Operator

Model DSBG - DC Single Arm Barrier Gate Operator

Technical Specifications:

• Power requirements: 115 Volts, 1 Phase
• Available horse power: 1/2 HP
• Class 2 low voltage control circuit
• Maximum arm length: 16 feet
• Maximum cycles per hour: 100 CPH
• Travel Speed: 90 degrees in 4 seconds std.
• U/L listed
• Shipping weight: approx. 200 lbs

Optional Equipment:

• Radio Controls
• Safety Edge (contact safety sensor)
• Photo Cell (non-contact safety sensor)
• Loop Detector
• Gear Box Heater (for cold climates)
• Interior and Exterior Control Stations:
  
  • Push Buttons
  • Push Buttons with keyed Lockout
  • Key Switches
• Light Kit to increase arm visibility at night
• Audible Warning Horn or Warning Lights

Electrical Specifications:

• Solid state controller with diagnostic LED s to facilitate maintenance and trouble shooting
• Built-in Radio Receiver
• Plug-in Loop Detectors
• Adjustable Timer to Close
• Maximum Run Timer
• Master/Slave option with dedicated terminal connections provided
• Spike suppressing circuitry for surge and lightning protection
• Anti-tailgate circuitry with dedicated connection terminals and LED indicator
• Safety interlock protecting side access door
• Internal On/Off power switch
• Two grounded 115 VAC, Convenience receptacles
• NEMA 1 three-button control station included

 Mechanical Specifications:

• Heavy duty #13 Ga. Galvanized steel frame providing a strong and durable unit.
• #13 Ga. Galvanized steel, lockable top cover and side door for easy access.
• 45:1, oil bath type, gear reducer, using a full 360 degrees rotation
• Heavy duty #50 sprocket and roller chain arrangement for intermediate drive reduction
• Heavy duty, pillow block type ball bearings, supporting output drive shaft and enabling extended endurance with low maintenance.
• Cam actuated limit switches ensuring consistent and accurate arm positioning.
• Soft start and stop at the open and close limits of travel, due to the inherent geometry of the internal drive linkage.
• Pad mounted for a strong solid installation.